Recon LED Bulb Resistor Kit (1 Piece)

We have found that most 2011 model years will require a resistor to be installed in order for the LED reverse light to function properly. This is due to the newer computers which run the vehicles lightning system. The LED's require lower voltage to run them which the computer thinks is a blown bulb. The resistor will in turn stimulate a load signal similar to that of a standard filament bulb.



LED bulbs may cause some newer vehicles to indicate a bulb is burnt out (because of their low power consumption). Some cars indicate this by increasing the flash rate of the turn signals, some turn on a bad bulb indicator. This can be remedied with our Load Resistors wired across the turn signal bulbs to simulate a filament bulb load.

This 6 Ohm, 50 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb (2 Amp load). This will solve LED related turn signal problems such as hyper flashing or burnt out bulb indications. This LED Load Resistor can be use with most signal or brake light which uses SINGLE or DUAL FILAMENT LED light bulbs, like the 7443, 1157, 3157, 4157, 1156, 7440, 3156 etcLearn More

FUNCTION: Map lights, or the pair of lights above your front seats, use incandescent bulbs from the factory, giving them a yellowish color. By replacing these factory bulbs with LEDs, you can add a luxurious and modern look to your vehicle, with a cool white color, just like the map lights on newer luxury vehicles. You can also increase the brightness with SMD5 or SMD9 bulbs, to improve the performance of your map lights. The installation is 100% plug-and-play, just replace your factory bulb!

BULB DESIGN
SMD2: Compact design, with two 5050-size Epistar SMD chips mounted directly to the base connector. Direct replacement, plug and play.
SMD5: Each of the four sides of this bulb contains one 5050-size Epistar SMD chip, and the top is fitted one more, for full-coverage, non-directional output. Direct replacement, plug and play.
HP3: One high-power SMD under a diffusing lens for truly even output (no hotspots). Constant current design and air-cooled base for superior reliability. Features dual contact pins and nonpolar function for easy installation.
SMD9: Similar to stage 2 design, with two chips on each side and a single chip on top, for non-directional output and increased brightness. Direct replacement, plug and play.

Included in your order is TWO BULBS.

Learn More

FUNCTION

License plate bulbs are used to illuminate the rear license plate on your vehicle. From the factory, the bulbs are incandescent, lighting up in a yellowish color.

Newer luxury cars use LED modules to illuminate the license plate with modern, cool white light. By changing your license plate bulbs to LED, you can easily add this luxury look to your vehicle!

The installation is 100% plug-and-play, just replace your factory bulb.

With low price and easy install, this is one of the best, easiest modifications you can do to improve how your car looks at night.

BULB DESIGN

SMF2: Compact design, with two 5050-size Epistar SMD chips on a standard festoon base. Directional output. Direct replacement, plug-and-play.
SMF4: Similarly compact design, with four 5050-size Epistar SMD chips, for maximum effective brightness. Standard festoon base. Directional output. Direct replacement, plug-and-play.

Included in your order is TWO BULBS.

Learn More