FUNCTION

License plate bulbs are used to illuminate the rear license plate on your vehicle. From the factory, the bulbs are incandescent, lighting up in a yellowish color.

Newer luxury cars use LED modules to illuminate the license plate with modern, cool white light. By changing your license plate bulbs to LED, you can easily add this luxury look to your vehicle!

The installation is 100% plug-and-play, just replace your factory bulb.

With low price and easy install, this is one of the best, easiest modifications you can do to improve how your car looks at night.

BULB DESIGN

SMF2: Compact design, with two 5050-size Epistar SMD chips on a standard festoon base. Directional output. Direct replacement, plug-and-play.
SMF4: Similarly compact design, with four 5050-size Epistar SMD chips, for maximum effective brightness. Standard festoon base. Directional output. Direct replacement, plug-and-play.

Included in your order is TWO BULBS.

Learn More

BULB DESIGN
HP5: Four high-power SMDs, under a diffusing lens. Just like the HP3, but run at higher power, with integrated copper plating for superior heat dissipation, allowing maximum brightness.
HP36: Full 360 degree illumination with 36 High-Power Samsung LEDs. Aluminum base for optimum heatsinking, and non-polar design for easy installation.
XP50: Each of the four sides of this bulb contains two 5W-rated chips, and the top is fitted with two more under a projector lens. Housed in an aluminum casing with textured finish for maximum heatsinking properties.
Fitment. All three bulbs use a quality inject-molded 921 terminal, with a sturdy base connector and proper pin alignment, designed for exact replacement of your factory 921 bulb. You will not need resistors for backup lights. Just replace the factory bulb.

Included in your order is TWO BULBS.

Learn More

When you replace incandescent turn signal bulbs with LEDs in most vehicles, the vehicle will start hyper-blinking because the LED uses much less power, and the vehicle thinks the bulb is out. You can use these resistors to fix the problem of hyperblinking when you convert to LED bulbs.

Diode Dynamics resistors have extra-long 8" leads for easier installation, and have a rating of 50w, 6ohm. This is usually enough to compensate for one bulb. If you are installing four LED turn signals (front and rear) we recommend four total resistors.

Included with your order:

2 resistors
4 quick-splice "scotch-lock" connectors
Learn More

Features
Direct replacement for factory incandescent bulb
Increased output with LED Appearance
Plug and play, simple installation
Available in multiple brightness levels.

Learn More

BULB DESIGN
HP5: Four high-power SMDs, under a diffusing lens. Just like the HP3, but run at higher power, with integrated copper plating for superior heat dissipation, allowing maximum brightness.
HP36: Full 360 degree illumination with 36 High-Power Samsung LEDs. Aluminum base for optimum heatsinking, and non-polar design for easy installation.
XP50: Each of the four sides of this bulb contains two 5W-rated chips, and the top is fitted with two more under a projector lens. Housed in an aluminum casing with textured finish for maximum heatsinking properties.
Fitment. All three bulbs use a quality inject-molded 921 terminal, with a sturdy base connector and proper pin alignment, designed for exact replacement of your factory 921 bulb. You will not need resistors for backup lights. Just replace the factory bulb.

Included in your order is FOUR BULBS.

Learn More