Unlock 50-70+HP on your boosted vehicle while decreasing your air temps by up to 100 degrees! Increase your pump gas octane by 25 points and make more power efficiently with a cooler running motor! The Snow Performance Stage 2 Boost Cooler® water-methanol injection kit is available for all forced induction applications (supercharged/turbocharged) and uses a progressive controller with built in manifold absolute pressure (MAP) sensor that proportionally injects more or less water-methanol according to boost pressure. Start and full points are adjustable for engagement and delivery curve to match what the engine requires. Proportionally injecting according to boost pressure gives an accurate delivery of water-methanol and allows cooling and performance improvements over a wide range for improved drivability. Comes with adjustable progressive VC-20 engine mount controller, 4AN fittings, and stainless steel braided line to mount pump/tank in engine bay of vehicle. For trunk mount options see Part# SNO-40014-BRD, SNO-40012-BRD.Learn More
Benefits: Made In USA Cooler Denser Air Charge Achieve 116 Octane Quality Fuel From Pump Gas Safely Run More Boost & Timing Cleans Engine Combustion Of Carbon Build Up Progressive Water-Methanol Injection
The Snow Performance Stage 3 Boost Cooler® brings true 2D mapped water-methanol injection delivery to your EFI (electronic fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3 creates a 2D injection map based off boost and fuel injector pulse width to deliver a extremely accurate amount of water-methanol when the engine needs it most. Bringing fuel injector pulse width into the mix allows the injection curve to be extended past specific boost points for greater range/control. None invasive, the Stage 3 Boost Cooler® controller is designed to mount on the steering column or the dash so no additional gauge pods need to be purchased and functions as a boost gauge, water-meth controller and fuel system monitor all in one! Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25 points for maximum HP and cooling . Comes with adjustable Stage 3 water-meth controller, 4AN fittings, and stainless steel braided line to mount pump/tank in engine bay of vehicle. For trunk mount options see Part# SNO-40014-BRD, SNO-40012-BRD.Learn More
The Snow Performance Stage 3 Boost Cooler® brings true 2D mapped water-methanol injection delivery to your EFI (electronic fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3 creates a 2D injection map based off boost and fuel injector pulse width to deliver a extremely accurate amount of water-methanol when the engine needs it most. Bringing fuel injector pulse width into the mix allows the injection curve to be extended past specific boost points for greater range/control. None invasive, the Stage 3 Boost Cooler® controller is designed to mount on the steering column or the dash so no additional gauge pods need to be purchased and functions as a boost gauge, water-meth controller and fuel system monitor all in one! Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25 points for maximum HP and cooling . Comes with adjustable Stage 3 water-meth controller, 1/4" High Temp Nylon line and easy to install quick-connect fittings.Learn More