Synergy MFG Jeep Front Lift Springs JK 2 DR 3.0 Inch 4 DR 2.0 Inch Jeep TJ/LJ 3.0 Inch Synergy MFG - 8063-20

Synergy MFG Jeep Front Lift Springs JK 2 DR 3.0 Inch 4 DR 2.0 Inch Jeep TJ/LJ 3.0 Inch Synergy MFG (1984-2017 Cherokee, Wrangler) - 8063-20

Synergy Jeep JK / TJ / LJ / XJ 3 Inch Front Lift Coil Springs
Fits and Lifts:

• 07-Present Jeep Wrangler JK Lifts 3 Inch
• 07-Present Jeep Wrangler Unlimited JK Lifts 2 Inch
• 97-06 Jeep Wrangler TJ Lifts 3 Inch
• 04-06 Jeep Wrangler TJL Lifts 3 Inch
• 84-01 Jeep Cherokee XJ Lifts 0.5 Inch

Details:

• Front lift coils for 2 DR Jeep JK TJ/LJ, XJ and 4 DR Jeep JK Wranglers
• Synergy coils offer excellent off road performance while preserving ride quality
• Progressively wound; keeps spring from coming unbound at suspension droop
• Progressively wound spring eliminates annoying spring clanking found on most suspension kits
• Feature frequency balanced and tuned spring rates to maximize suspension performance on and off road
• Suspension components feature an abrasion-resistant black Powdercoat finish for maximum durability and corrosion resistance
• Springs are designed to give the advertised amount of lift with use of aftermarket front bumpers wInch.
• Sold in Pairs

Notes:

• 2012+ JK's lifted over 2 inch will require exhaust spacers (5017), or a front aftermarket drive shaft to prevent interference with the exhaust
• Springs retain the factory rake of the vehicle where the rear is higher than the front. Vehicle should sit level when loaded. Request one size shorter rear springs to level the vehicle out when unloaded
• Lift heights listed for JK are for models with gas engines. Expect approximately 1 inch less lift on diesel models
• Lift heights listed for TJ/LJ and XJ are for models with the 4.0L engine. Expect approximately 0.5 inch-1 inch more lift on 4 cylinder models
• For JK's with stock wheels or wheels with close to stock backspacing, 1-1/2 inch wheel spacers are recommended
• For JK's with 35 inch tires, 3 inch bump stop spacers are recommended. With high fenders, shorter bump stop spacers can be used
• For JK's with 37 inch tires, 4 inch bump stop spacers are recommended. With high fenders, shorter bump stop spacers can be used
• For 2 Door JK's with 5.5 inch of lift or more, the Synergy Long Arm System is recommended
• When a 4 cyl engine is used, expect 0.5-1 inch more lift
• When a diesel engine is used, expect 1 inch less lift

Lethal Performance is proud to offer the entire line of Synergy MFG products!