A jacking rail is nice, but a single point is easier to install, lighter, and will lift more consistently. These are supplied raw unfinished and have to be welded in. The main donut on the bottom of the jack point is strong .25-inch -thick steel, and the side load plates are 1/8-inch steel plate. TIG welded.
This kit includes a pair (left and right) of Watson Racing Jack Point Plates for the S550 Mustang. Learn More
Service replacement part for the original equipment on our factory-built Drag Race and Road Race Cars! Fits all 2015+ S550 Mustangs, including EcoBoost and V6. We use these on both drag race and road race S550 Mustangs. Fabricated from ¼-inch thick steel plate and zinc plated for long life. Powder coated parts are nice, but parts that see frequent removal will chip over time. Zinc plating is superior and will last a lifetime!
Includes all necessary hardware and instructions; some drilling required. Learn More
Our newest updated model of our 2005-2020 Mustang front bumper support. Now weighing in at a ultra lightweight 2.4 lbs.(that is including powdercoat and sticker) it is 1/3 less weight than our previous model. Not only is it the lightest on the market but also allows more room for intercoolers than most models on the market. Made of strong yet lightweight 4130 chro-moly , it is the lightest material without going to a very expensive titanium material. Finished with a high gloss black powdercoating and TigVision sticker so you know it is made in the USA and is a high quality race part designed and made right here in house. Uses all factory hardware.
"""" These bumper supports are for racing only and offer no safety protection in an impact. These are not approved for highway use and meant for use as a lightweight alternative on offroad vehicle only"""'Learn More