For those who already have an Aeroforce gauge these provide an inexepensive and easier alternative to buying and installing separate gauges for these functions. Both sensors have a range of 150 psi and come with the proper mating connector and 5' pigtail. They have a 1/8" male NPT fitting. These sensors use a constant 12v power source, so they are included with a 12v regulator as the variable voltage system on todays vehicles will not power the sensor properly. We also carry -4 adapters to help with fuel pressure installation. 

Learn More

The new Aeroforce 2015-2018 Mustang Performance Pack Gauge Adapter allows you to replace the factory Performance Pack gauges with any 2 1/16” or 52mm gauges. Don’t limit yourself to what Ford gave you, install any gauge you want in the factory location with this adapter that directly replaces the factory gauge module without any modifications needed. Can also be used if retrofitting the Performance Pack dash trim with dual gauge openings in a non-Performance Pack Mustang.

Some trimming of insulation is required in this case. Gauge not included. Learn More

These pyrometers use an ungrounded tip type K thermocouple for maximum accuracy. They come with a 6' cable, weld in type bung, and 1/8" NPT fitting. Clamp style hardware also available as special order.Learn More

- Includes sensor and 5v regulator/signal conditioner
- includes connector/pigtail
- quick response
- 3/8" NPT fitting
- For use on boosted apps on pressure side (after Turbo or S/C)Learn More

- Includes sensor and 5v regulator/signal conditioner
- includes connector/pigtail. Learn More

- Includes sensor and 5v regulator/signal conditioner. Fitting is 1/8" NPT. 3/8" standard OEM also available upon request.
- includes connector/pigtail.
- Can be used to read engine oil temp, engine or liquid intercooler temperature, rear differential temperature, etc

1/8" NPT sensor shownLearn More

Contains everything you need to control a 12v 40A relay (included) via the annunciator function of the gauge. Kit includes necessary wiring, control module, and relay. Possible applications are controlling an electric cooling fan, turning on/off a water/alcohol injection kit, turning on/off a nitrous kit, etc. For example, one of our customers monitors knock retard and when an unsafe level is seen the gauge turns off his nitrous system. OBD2 parameters as well as analog inputs can be used to trigger the output. Firmware versions 2.6 (non CAN) and 3.4 (CAN) have the necessary code to use this module. The version number can be found on the back of each gauge. Prior versions will need to be reflashed. Contact service@aeroforcetech.com for details if you have an older version. 

NOTE: The speed and accuracy at which the relay activates is based on the vehicle's OBD2 bus. CAN bus vehicles will have the fastest response rates due to the increased speed of these communication systems. Our PT, FD, and SR series gauges use a slightly slower protocol but are still relatively fast (about 10x second), the ISO series may not be suitable for applications that require very fast response times due the slower nature of these buses. The user can determine if the response will be fast enough by watching the update rate of the parameters being displayed. The output/annunciator will respond at the same rate as the data shown on the display. Keep in mind that a data rate of "1" is the fastest. Refer to the user manual for the procedure of setting the data rate.

Learn More

For those who already have an Aeroforce gauge these provide an inexepensive and easier alternative to buying and installing separate gauges for these functions. Both sensors have a range of 150 psi and come with the proper mating connector and 5' pigtail. They have a 1/8" male NPT fitting. These sensors use a constant 12v power source, so they are included with a 12v regulator as the variable voltage system on todays vehicles will not power the sensor properly. We also carry -4 adapters to help with fuel pressure installation. 

Learn More