NEW TUBE DESIGN
The new JLT tubes are made from real Pre Preg Carbon Fiber fotr it's super strength, to resist engine heat and keep the intake air charge nice and cool. NO METAL TUBING HERE!!
We started from scratch, designing a kit that not only looks great, but installs easy and can flow enough air to support anything it’s put on.
NEW HEAT SHIELD DESIGN
The heat shield is all new as well. Vacuum formed from ABS plastic and designed to not only look good, but block engine heat at low speed and idle.
Real Carbon Fiber available as an upgrade below. $40 savings when purchased at the same time.
GAINS
18-26 RWHP are typical with this kit.
FINISH
Real Carbon Fiber
FITMENT
2003-04 Cobras with stock blower
AFTERMARKET BLOWER FITMENT IS TIGHT DEPENDING ON BLOWER SIZE, INLET & THROTTLE BODY
*Throttle body locations are different depending on if you have a stock blower, Kenne Bell, Whipple, aftermarket K-Member and or non stock motor mounts. Due to these variances the tube may touch the strut tower or some other part of the car.
WE ARE NOT RESPONSABLE FOR ANY DAMAGE TO THE KIT OR YOUR CAR DUE TO COMBINING AFTERMARKET PARTS.*
DOES NOT FIT WHIPPLE CRUSHER INLET
EASY INSTALL
The new design, detailed instructions and online video instructions helps make this an easy install.
KIT INCLUDES:
•JLT Carbon Fiber intake tube
•Silicone Coupler
•Silicone reducer
•ABS Heat Shield / Carbon Fiber optional
•4x9 S&B powerstack air filter
•MAF adapter
•MAF adapter gasket
•HD Clamps & all needed hardware
Will not fit with most strut tower braces.
Model | Year(s) |
---|---|
SVT Cobra | 2003 2004 |