Mcleod Shelby GT500 RXT Street...
Mcleod 2010 GT500 RXT Street Twin Disc Clutch Kit (Street) Includes: Mcleod RXT Clutch Mcleod Lightened Steel Flywheel NOTE: The 2010 GT50...//Shop Now
JLT 03-04 Cobra NEXTGEN Cold Air Intake Kit
NEW TUBE DESIGN
Using the original JLT CAI as a guide, we molded, sculpted and perfected everything until we had the best looking, fitting and performing system you can buy. The new JLT tube is 4 1/4" ID, roto molded ABS plastic to resist engine heat and keep the intake air charge nice and cool. NO METAL TUBING HERE!!
MAF and filter relocated into fender well for a cooler intake charge and can support 550-600 RWHP
MOLDED IN MAF
The best part of this new JLT Cold Air is we kicked the cool factor up a notch and molded a 105mm MAF housing right in the tube. Now you have a kit you can grow into and not have to buy a complete new kit when you reach over 550 RWHP. This cold air kit uses STOCK MAF electronics. Putting a Whipple or Kenne Bell blower on your 03-04 Cobra? Simply drill out the pre molded plug on the MAF block located on the bottom of the tube, discreetly out of sight. Install your SCT MAF 2600 or 3000 sensor electronics, add our huge 4.5 X 12” S&B Powerstack filter and you’ve now changed your JLT Cold Air Intake into a JLT High Boost 12” Intake. Molding the MAF into the tube makes for a much smoother air flow with no couplers, reducers or separate MAF housing and can support 800+RWHP for only the cost of the 12” upgrade kit, $60.00. Will not work with stock MAF, SCT 2400 or 2800 MAF
26-30 RWHP are typical with this kit.
The new design, detailed instructions and online video instructions helps make this an easy install.
•JLT plastic intake tube
•4x9 S&B powerstack air filter
•MAF adapter gasket
•HD Clamps & all needed hardware
Will not fit with most strut tower braces.
To properly clean your filter, we recommend the S&B Precision Cleaning & Oiling Kit.