MSD Crank Trigger Kit - 8619
Crank Trigger Kit
Fits Small Block Chevy - LS Gen III/IV
7.25 in. Diameter
Billet 6061-T6 Aluminum Trigger Wheel
5-20 Volt Operating Voltage
Hall Effect Sensor Type
Red
Most Accurate Way To Trigger Your Electronic Fuel Injection
3-Wire Hall-Effect Sensor Not Easily Susceptible To Interference
Allows Precise Indexing
Easy To Install
Rigid Mounting That Will Not Flex And Cause Timing Fluctuation
Upgrading to an MSD Flying Magnet Crank Trigger Kit will deliver the precise and reliable signal that a high performance engine requires. This kit gives you the ability to control timing electronically through a Holley EFI ECU (or other standalone engine management system / ignition controller). At the heart of the kit is the 3-wire Hall-Effect Sensor that is easier to set up, less susceptible to EMI/RFI interference/noise, and less likely to have false signals than other methods (Distributors and VR Magnetic Sensors). In addition, they are less prone to mechanical failure since there are no wear parts. With the included high quality timing pointer and the use of a direct bolt-on, degreed balancer (ATI 917777 or 917211), you'll be able to adjust timing in the precise increments required for your LS Engine.
Your performance electronic source for ignitions, coils, distributors, timing controls, spark plug wires, starters and electronic fuel injection.
