IHC Suspension 1999-2006 GM 4" LOWERING CONTROL ARMS - IHC-GM9906CA-45
Kill 2 birds with 1 stone. Not only are you lowering the truck but also
replacing your 15+ year old ball joints and bushing with IHC control arms.
IHC integrates the notorious 99-06 chevy LEAN! What is the chevy lean? Most
customer find out the hard way. 99-06 was known for driver side being 1
full inch lower which most noticeable after lowering the pickup truck. IHC
as a previous installation shop understood the frustration. When
engineering designed and developed 9906 control arms. The chevy lean
correction was a must had to make pick-up truck sit level. HOW? Driver side
springs pocket is not as deep as passenger side making all 4 corners sit
leveled.
IHC control arms run Delrin bushing for maximum performance, extended
bushing life, and minimal maintenance.
All MADE IN USA!
Manufactured in TEXAS!
Lifetime warranty on all metal parts!
Please read Instructions thoroughly and completely before beginning
installation. Installation by a certified mechanic is recommended. IHC
Suspension is NOT responsible for any damage or failure resulting from
improper installation
Estimated Installation Time: 3.5 Hours +/- 1 hour (excluding alignment)
4/6 tallest tire 30.5″
5/7 tallest 29.3″
Larger wheels recommend to check with local suspension shop
Fits all 2wd coil spring front suspension
WILL NOT WORK ON TORSION KEY SUSPENSION or 4WD
5” Lowering control arms (upper and lower)
1” rubber isolator (used to set at 4” front drop)
Shorter sway bar link
WEIGHT: 56 LBS.
DIMENSIONS: 20″X20″X10″
