Improves Air Flow for More Power
Engineered Using Computational Fluid Dynamic Data
MAF Sensing System with 120mm Intake Tube
Velocity Stack Design Maximizes Flow without Turbulence
Reusable S&B Air Filter Included
NO Computer Tune Required
Simple Bolt-On Installation
Fits All 2015-2017 GT Mustangs
More Air For More Power.
Are you a S550 owner that is looking to increase the horse power and torque of your 2015-2017 GT Mustang? If so, get rid of that restrictive stock air intake. The factory intake was designed to meet the requirements of a mass produced commuter vehicle, not the demands of a high performance muscle car. That is why PMAS designed their No Tune Velocity Cold Air Intake to significantly improve incoming air flow, when compared to stock, for a boost of horsepower and torque. After installation you will also experience a noticeable improvement in idling, throttle response and over all performance.
No Tune Required.
PMAS engineered their Velocity Cold Air Intake to improve the power and performance of your 2015-2017 GT Mustang without the need of reprograming the factory computer (ECU) for operation. However, they do recommend the use of a Handheld Tuner to reach even larger power gains, than just their Cold Air Intake alone.
Designed with maximum flow as the first priority, this PMAS Velocity Air Intake was engineered with computational fluid dynamic “CFD” data for minimum restrictions. Featuring a patented mass air flow sensing system, this Cold Air Intake effectively uses a massive 120mm intake tube with no MAF resolution loss. The unique Velocity Stack inlet design maximizes airflow without turbulence for smooth, stable idle air flow which results in stock drivability.
Reusable S&B Air Filter.
The included high flow S&B Filter effectively filters out power robbing contaminants with its multi layer design. S&B Air Filters are made up of eight layers of specially treated cotton media that are mounted between two epoxy-coated wire screens. The red oil used to treat the cotton layers creates a sticky surface to capture harmful microscopic particles before they can enter your Mustang's engine. Seeing that the filter is reusable there is no need to buy a new filter every few thousand miles. You can just clean the filter, re-oil it, and reinstall - saving yourself money in the long haul.
Straight Forward Installation.
PMAS designed their Velocity Cold Air Intake kit to easily install in under an hour. Installation can be completed with just basic hand tools, no extra modifications or special tools are required. All necessary hardware and instructions are included.
This PMAS Velocity Cold Air Intake System is specifically designed to fit the 2015-2017 GT Mustangs equipped with the 5.0L Coyote V8 engine and does not require re-tuning of the vehicles computer for operation.
This product is not legal for use in California or any other state adopting California emission standards. Not legal for use on pollution controlled motor vehicles; intended for off road use only.