*All images are for illustration purpose only. Actual product may vary
 WARNING : Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Snow Performance
SKU : SNOW-2130

Snow Performance 05-2010 Mustang GT Stage 2 Boost Cooler

$599.99
free shipping on this item
Customer Reviews
Description

Details

The all new Snow Performance Stage 2 Boost Cooler® is the only water-methanol injection system tailored to your forced induction (supercharged/turbocharged) 2005-2010 Mustang GT. Equipped with the new boost referenced VC-50 (1-50 PSI) controller, the Stage 2 will progressively command injection along the boost curve when water-methanol is most needed. Taking it one step further, the VC-50 controller has the ability to progressively command 2 Hyper-Sonic™ Nozzles independently of one another. This sophisticated injection strategy yields the highest increases in HP and cooling along all stages of the engine allowing you to greatly increase the boost & timing of your mustang. Proven to deliver 50-80 HP and cool inlet temps up to 150 degrees! The VC-50 comes with a dual 7 color OLED screen and displays boost, percentage of injection, low level, and secondary nozzle activation directly on the screen. Utilizing a 4.6L Snow Performance Injection plate no drilling is required of the intake piping and allows the location of 2 Snow Performance Hyper-Sonic™ Nozzles right where you need them. Complete with the industry leading Snow Performance 300 PSI UHO pump and Hypersonic Nozzles™, the Stage 2 promises to deliver the best atomization and power available. If you are looking for the most advanced, high quality, U.S.A made water-methanol injection system tailored to your 4.6L Mustang GT look no further than the Snow Performance Stage 2 Boost Cooler®.

Kit Includes:
  • 4.6L Mustang GT Injection Plate
  • Stage 2 Hybrid Controller
  • 300 PSI UHO (Ultra High Output) Pump
  • 3 Quart Reservoir
  • All Tubing Necessary for Installation
  • 10 ft ¼ Inch High Temp Nylon Tubing
  • 18 Inches High pressure Boost Line
  • 3 ft (Black) Wire Loom
  • Pig Tail Harness
  • 1 Nozzle Holder/Check Valve Combo
  • 2 Snow Performance Nozzles to Cover a Wide Range of HP
  • Required Hardware Needed For Installation
  • Comprehensive Instructions to Install on Any Forced Induction 2005-2010 Mustang GT
  • Snow Performance 1-Year Warranty

  • Note: Only for forced induction applications (turbocharged/supercharged)

    Vehicle Application(s)

    This product fits the following models and years

    ModelYear(s)
    Mustang GT2005 2006 2007 2008 2009 2010
    Reviews

    Write Your Own Review

    Q&A
    Recently viewed products