Moroso NHRA Legal Battery Box Cable Kit

MOROSO Battery Box Cable Kit Features:

Moroso NHRA Legal Battery Disconnect Switch

Moroso's battery disconnect switch splices into the battery cable to provide a direct power shutoff of the electrical system. This cutoff is useful during battery charging or whenever the car is not in use. MANDATORY by NHRA in vehicles with battery in trunk.Learn More

Master Disconnect Switch - Universal - Chrome Plated

This switch is spliced into the battery cable to provide a direct power shutoff of the electrical system. This cutoff is useful during battery charging or whenever the car is not in use. Continuous Rating: 20amps at 12V/40amps at 6V. Momentary Rating: 125amps at 12V, 250 amps at 6V.

Mr. Gasket Master Disconnect Switch positively shuts off all of the current from the battery in the event of a short or accident. It includes an adhesive decal to show both on/off positions and detailed instructions for a safe installation.

Learn More

* 8.1 NHRA Legal Aluminum Battery Box Kit* 1.5 hour install* 16ft of 2 gauge Positive Wire* 4ft of 4 gauge Negative Wire* Aluminum Box* Inside Dimensions 13 1/8" wide, 9 1/8" deep, 9 3/4" tall* All hardware included* Brushed FinishUPR's 8.1 NHRA Legal Ultra Light Weight Aluminum Battery Box Kit for your 1979-2013 Ford Mustang. This is a bolt in kit for the front or rear of your vehicle. The kit includes all necessary hardware including a breather tube for a clean and hassle free install. Includes: Positive Battery Cable, Negative Battery Cable, Aluminum Battery Box, Grommets, Cable Mounts, Battery Hold Down, Nuts and Washers, Wing Nuts, Vent tube Fitting, Battery Cable Ends, Threaded Rods.Learn More

Includes a plastic battery case molded from polyethylene, battery hold-down and brackets, 20' of 2 ga. stranded copper battery cable, 4 lugs, a pair of cable ends and related hardware. Case measures 12" x 6 3/4" x 10" high. Bulk packaged. This battery box is a must for all high performance applications. This allows the weight to be put where it is needed, on the rear of the car for proper weight transfer. Putting the battery in the rear is also great for safety reasons and giving you more room in the engine compartment.Learn More

The only battery relocation kit CUSTOM-FIT to both the S197 and the S550 MUSTANG! There are many cheap battery trays, boxes, and relocation kits available on the market, but all of them are generic and require some heavy duty tools to crimp the heavy-gauge battery cable. Watson Racing is proud to offer you this complete Mustang Battery Relocation Kit that is 100% ready for you to bolt in with typical hand tools. All of the super-flexible 2-gauge wire is pre-cut, with ring terminals and shrink wrap already installed. We even include a battery terminal stud that accepts your factory battery cable, so you DO NOT have to modify your factory battery wires! It’s genius!! The battery tray is derived from the very same tray we use on our factory built drag cars- it is powder coated and built tough for all driving conditions- whether road racing, drag racing or just cruising the streets. The battery tray also includes a heavy duty OEM-quality fuse holder (fuse included), so you are ready to rock once you have this installed. Only minimal drilling involved for mounting the battery tray; everything else is completely plug-and-play.

**Choose LH (driver’s side) or RH (passenger side). Some cars are factory equipped with a subwoofer enclosure, so you have the choice of mounting the battery tray on either side of the trunk. Wire lengths are specific to each kit!Learn More