Keep the differential temperature down and avoid burning-up the stock Ford Traction-Lok differential in your 1999-2004 Cobra with MMs IRS Differential Cooler. The IRS center section is subjected to much more heat than a solid axle differential. The additional heat comes from the exhaust being routed directly underneath the IRS differential, the reduced fluid capacity of the IRS center section, and the absence of large steel axle tubes to act as heat sinks. The Cobra IRS has gained a reputation for burning up the Traction-Lok differential during spirited driving and open-track events. With MMs new Differential Cooler kit, costly limited slip failures caused by excessive heat can be avoided.
Note: Fits aftermarket differential cover braces, with a minor modification to the brace.Learn More
Maximum Motorsports IRS Differential Oil Temperature Sensor Kit for OC-10
Keep tabs on the temperature of your Mustang Cobra IRS differential fluid with this Maximum Motorsports kit. This MM kit is designed to allow installation of a temperature sensor with the MM IRS Differential Oil Cooler Kit (OC-10).
This MM In-Line Differential Oil Temperature Sensor Kit allows you to choose where you want to locate a temperature sensor, giving you the freedom of measuring temperature values that are important to you; you can check on the temperature of the fluid either entering or exiting the cooler. When properly installed, the high quality AN fittings provide leak-free performance. The MM In-Line Temperature Sensor Kit will only work with an Autometer 1/8" temperature sensor. This kit does NOT include a temperature sensor however it's available here at Lethal Performance.Learn More
Maximum Motorsports Tool Package for IRS Differential Cooler
There is no need to spend time searching for the proper taps and drill bits with this Maximum Motorsports Tool Package. Includes the thread taps required to install the OC-10 MM IRS Differential Cooler, and the correct matching drill bits for those taps. Thread taps included are 1/4-18 NPT and 3/8-18 NPT; drill bits included are 7/16", 9/16" reduced shank, and 3/4" reduced shank.Learn More
Kit includes a heat exchanger/fan assembly with -8 fittings, Tilton oil pump, 15 feet of -8 stainless braided line, three 90 degree -8 fittings, seven straight -8 fittings, one 90 degree swivel for the suction line, one AN-8 check valve, one 280 degree temperature gauge with sending unit.Learn More
