Ford Racing 99-04 Cobra 8.8" IRS BEARING AND SEAL KIT

For use in rebuild 8.8'' IRS differentials

Kit includes 2 stub shaft pilot bearings, and 2 stub shaft pilot bearing housing sealsLearn More

Stabilize the differential by removing the OEM front differential rubber bushings and replace them with this kit.

Stabilizing the differential will prevent diff cover leakage and in high torque situations, diff cover and halfshaft breakage.

Be sure to replace both the front and rear differential mounts at the same time.

Fits Mustang Cobra
1999, 2000(R), 2001, 2003, 2004Learn More

Included in this kit are 2 Delrin rear differential bushings and one anodized inner sleeve.

Stabilize the differential by removing the OEM rear differential rubber bushing and replacing it with this kit.

Stabilizing the differential will prevent diff cover leakage and in high torque situations, diff cover and halfshaft breakage.

Be sure to replace both the front and rear differential mounts at the same time.

This kit is included in our FT 5000 complete IRS bushing kit.

Fits Mustang Cobra
1999, 2000 (R), 2001, 2003, 2004Learn More

Included in this kit are the anodized rear diff lowering mount fully assembled with the Delrin bushings and crush sleeve.

(Diff cover not included, shown mounted on a milled (FT 1350M) Ford Racing rear diff cover.)

Eliminate driveline vibe and completely optimize your driveline angle with this mount.

This mount is included in our FT 5001 complete IRS bushing kit.

This mount will fit the OEM Ford differential cover and is also fully compatible with the new milled Ford Racing reinforced rear differential cover.(Full Tilt Boogie Racing Part# FT 1350M)

Fits Mustang Cobra
1999, 2000 (R), 2001, 2003, 2004Learn More