MMCO-2 Mustang Front Coil-Over conversion kit for Koni/Tokico/Strange and 2.2" Lakewood struts including springs. See below for more Lakewood info. This kit comes with Hypercoil springs in your choice of spring rate. Read the Guide to Choosing Spring Rates and Dampers for help choosing spring rates for your mustang.

Fits

Koni Sport SA and DA struts

Tokico Illumina and D-spec struts (some modification to strut body required; see MMCO-2 installation instructions).

Strange adjustable struts, pre 2017; see the important note below.

Lakewood struts having a 2.2" diameter strut housing diameter. Measure yours! Some modification to strut body required; see MMCO-2 installation instructions.

Lakewood struts having a 2.0" diameter strut housing diameter. Measure yours!

QA1 struts

Strange struts: It appears that in 2017 Strange changed the powder coating on their strut housings. The new coating is sometimes thick enough to prevent installing a threaded coil-over sleeve onto the strut housing. This doesn't just apply to MM sleeves; Strange's own sleeves also have this same potential interference.

Sand the outside of the strut housing by hand. This will work only if the interference is very small. If 5 minutes of sanding is not enough to slide the threaded sleeve on, proceed to step 2.

Put the struts into your freezer overnight. Put each threaded sleeve into a pot of water, and bring the water to a boil. Remove the hot sleeve (take care to avoid getting burned) and slip it over the cold strut housing.