Lethal Performance Power Pack - Ford Performance ProCal 4 with Whipple Intercooler and Roush Intake (2021-2023 Bronco 2.3L/2.7L)

Will fit all 2.3L and 2.7L Broncos with or without active cruise and collision assist. The shutter fans get removed.  The sensor is retained with a supplied bracket which the shutter motor mounts to.

Enhance the performance of your 2.3L or 2.7L engine in your 2021-2023 Bronco. The Ford Performance engineered and dyno tested calibration delivers the Ford Performance promise of more power and increased performance without sacrificing reliability.

2.3L Features:
Improved throttle response throughout RPM range
Optimized shift schedule for automatic transmission equipped vehicles
Down-shift rev matching for manual transmission equipped vehicles
Peak torque = 385 lb.-ft. at 3,500 RPM
Peak power = 330 HP at 5,500 RPM
Ability to change tire size up to BFG 37x12.5R17 KO2 size (579 revolutions per mile)
[Additional modifications required]
Ability to change axle/FDU ratio up to 5.38
Enables upgrade of M190 to M210 front drive unit by reconfiguring DLCM module
For U.S. and Canadian vehicles
3 year/36k mile warranty from new vehicle in-service when installed by a Ford dealer or ASE/Red Seal certified technician
CARB E.O. #: D-431-4 for 2021-2023 model year vehicles
M-12655-F ProCal 4 delivery tool included
* Premium fuel required*

2.7L Features:
Improved throttle response throughout RPM range
Optimized shift schedule
Peak torque = 433 lb.-ft. at 3,500 RPM
Peak power = 355 HP at 5,500 RPM
Ability to change tire size up to BFG 37x12.5R17 KO2 (579 revolutions per mile). [Additional modifications required.]
Ability to change axle ratio/FDU up to 5.38
Enables upgrade of M190 to M210 front drive unit by reconfiguring DLCM module
For U.S. and Canadian vehicles
3 year/36k mile warranty from new vehicle in-service when installed by a Ford dealer or ASE/Red Seal certified technician
CARB E.O. #: D-431-4 for 2021-2023 model year vehicles
M-12655-F ProCal 4 delivery tool included
* Premium fuel required*

***Calibration and ProCal 4 tool are VIN locked. Please contact the Tech Line with additional questions***

***NOTE*** ProCal 4 software only available for Windows 7 or greater. Will NOT work with Windows 10 in "S Mode".

***NOTE*** Speed Limit is not raised with this calibration.

***NOTE*** ProCal 4 tool receives periodic firmware updates for greater usability and additional features. Please connect tool to PC periodically to receive the updates automatically.

***NOTE*** This Item cannot be returned

2021 Bronco R Series Intake Features:
High-capacity air filtration system
See-through window
Enhanced turbo sounds
Pre-filter included with "R" logo
Fits both 2.3L and 2.7L

Whipple Mega Cooler Intercooler Features:
Direct Bolt-On Replacement for Factory Intercooler
58% Larger Internal Core Volume
144% Increase in External Fin Surface
12% Less Restrictive than the Stock Intercooler Core
Tig Welded Bar and Plate Design
Cooler Intake Air Temps
Increased Horsepower and Torque

Fitment:
2021-2023 2-Door 2.3L/2.7L Ford Bronco
2021-2023 4-Door 2.3L/2.7L Ford Bronco

Does Not Fit Ford Bronco Sport