Details
Please be advised lead time is around 4-5 weeks on this item.
Leash Electronics Boost Leash, gear based, 1-6 gears - 4
Billet map/pressure sensor now come standardNew gear based Boost Leash now available. Simple 4-5 wire hook-up. Ign
voltage, ground, scramble ,clutch switch input and auxillary shift input(if
motorcycle option is selected below). Controller can run on co2 or manifold
pressure. Has a lunch psi setting, number of gears setting, and psi and
rate for each gear. The way it works is when the clutch is held for more
than 1 second it resets the gears to gear1 and puts the contoller in the
launch mode. When the clutch is release the controller goes into gear 1
mode and each time the clutch is pressed it goes to the next gear until the
final gear is reached. It only up shifts. It also has an optional shift
input that can be connect to air shifter controllers to up shift with a air
shifter setup on motorcycles if the motorcycle option is selected below. So
to reset down to 1st gear you just hold the clutch for over 1 second and it
goes back to gear 1. The controller also has automatic activation so that
you dont need a seperate activation switch. When the controller senses more
than 2psi boost then it becomes active and runs whatever is programmed.
This controller is also perfect for turbo motorcycles!If this is for a Motorcycle select that in the options!More info about these boost controller can be read on the standard Best
Seller Boost Leash description.I sell line and fitting kits in the Boost control section. If you need a
co2 bottle and regulator I recommend these part numbers from www.jegs.com Bottle 555-60207 Regulator 376-RG
Options - -- Select --
For a Motorcycle