Mcleod Shelby GT500 RXT Street...
Mcleod 2010 GT500 RXT Street Twin Disc Clutch Kit (Street) Includes: Mcleod RXT Clutch Mcleod Lightened Steel Flywheel NOTE: The 2010 GT50...//Shop Now
Its been a long time since we have seen the Mustang with a IRS under it, gone are the Days when they used a Thunderbird 6cly IRS and put them under 400Hp Cobras. The 2015-2018 Mustang seems to have a decent diff under it, Rumor has it the diff is a "Super 8.8" (not sure what that means but we like the sound of it) and one of the best improvements i have seen is the introduction to a rolled formed wheel bearing, as most know the 03-04 Cobra had he same wheel bearing and spline size as the 6cly Thunderbird and after putting any HP into them the spline and bearing would break, We used the custom hubs to stop the spline breakage but still the wheel bearing was an issue. Well say good buy to both issues, The new Mustang has a full 32 spline going into the hub (and a beefy 34 spline in the diff up from the 31 spline of yesteryear)
So what did DSS do to make this set of axles the best options ? 1st we started with both the inner and outer splines going into the Hub and the Diff, We have been working with Ovaco steel our of Sweden and they came up with a material called Ovaco 300 that has been used by DSS in each and every IRS/CV driven world record breaking car to date (includes Mark Carlyle s amazing Vette running 6:82 with a 1.1 60ft time,many other cars in the 7's,8's and 9' also) so each spline is now this amazing 300m material (on both the 800hp and the 1400hp) we then made 4340 billet CV mounts and are using our proven 108mm CV with full 300m Billet Chromoly cage and race (1400hp axles using the larger 30 spline bars) this along with Neo HPCC1 grease and with a higher durometer Neoprene boot it will handle just about anything you can put to it, We dident stop there the center bars we made are done with Rolled splines, most "in the know" will tell you that a rolled spline is stronger than one that was done with material cut away (its actually forging the spline and compressing the micro structure to make it even stronger) So what we have here is a proven design, well maybe not enough so we also have taken the time to put caps on the ends of the axles in-case they are ever taken apart (you guys pulling the diff will love this after its done as the 6 bolts come off and the diff will come out, try this with a stock axle) and the Caps have blue RTV inside to ensure a perfect seal so no issues with that, so here you have the best axles on the market for one of the coolest cars to come out of Detroit in a while,Please note, these are build to order and can take 2-3 weeks.