*All images are for illustration purpose only. Actual product may vary
 WARNING : Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
FOR CLOSED COURSE COMPETITION USE ONLY. NOT INTENDED FOR STREET USE. THE SALE, USE, OR INSTALLATION OF THIS PRODUCT MAY ALSO BE ILLEGAL NATIONWIDE UNDER THE FEDERAL CLEAN AIR ACT (42 U.S.C. § 7522(A)(3))
Driveshaft Shop
SKU : DSS-GMCAZL1-A2

DSS 4" Aluminum Driveshaft (2012-2015 Camaro ZL1 with 4L80e and Stock Differential ONLY) - GMCAZL1-A2

$904.98
Quantity
Mustang performance parts, performance and tuning
OR
free shipping on this item
Customer Reviews

This product is for Racing Competition only and is not legal for use in highway or street vehicles or other non-racing competition off-road vehicles.

Purchasing this product requires you to sign our Vehicle Compliance Waiver HERE

Description

Details

Quick Overview
You will have to remove the heat shield from above center hanger mount to install a 3-1/2" shaft there is a possibility of clearance issues with aftermarket exhaust. This is a general warning. We have 9 test shafts out and not one had an issue. I have listed this because not all exhaust systems have been tested.

Product Description
Available now for the 2012+ Camaro ZL1 is our 3-1/2 aluminum shaft with CV . We have done extensive testing with stock rears and with our 9" kit and believe this to the the most cost-effective trouble-free driveshaft for the Camaro available today. The shaft will come with our signature billet plates for each end so you don't have to go into the rear taking a chance on upsetting the crush collar (see below for billet plate VS changing to a pinion yoke). Our shaft comes with a 300m stub system mounted into a billet aluminum plate to ensure not only strength but lighter weight than the normal way of doing this type of end (look closley at the CV end, it's not all steel). The shaft only weighs 17lbs and comes with special grade 12.9 uber strength hardware with back up lock nuts to ensure no loose bolts. We have been using this billet aluminum style plate for over 10 years on thousands of 1000+Hp Supras, BMWs and many more without any bolt issues.

You will have to remove the heat shield from above center hanger mount to install a 3-1/2" shaft there is a possibility of clearance issues with aftermarket exhaust. This is a general warning. We have 9 test shafts out and not one had an issue. I have listed this because not all exhaust systems have been tested.

Part Number: GMCAZL1-A2
Vehicle Application(s)

This product fits the following models and years

ModelYear(s)
Camaro SS 6.2L2012 2013 2014 2015 2016
Reviews

Write Your Own Review

Q&A