*All images are for illustration purpose only. Actual product may vary
 WARNING : Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Driveshaft Shop
Driveshaft Shop FDSH58-A 2007-2012 Shelby GT500 3-1/2" Direct Fit CV Aluminum One-Piece Driveshaft


New from The Driveshaft Shop! They have developed a DIRECT FIT rear CV Driveshaft! This new design eliminates the adapter plate at the rear end with a precision ground CV to fit inside the pinion flange just like the factory. This new design sheds weight from adapter plates while increasing power holding ability and drivetrain response.  Their Driveshaft will be an athletic upgrade from the factory soft rubber mounted shaft. Now offering solid connections, perfect alignment, and their new CV with chromoly internals / Spicer 1350 U-joint combination to get the power to the ground. Designed to hold over 1000+ horsepower, so even the most extreme engine modifications won't be a problem.


3.5" diameter aluminum construction
Billet aluminum endcaps
300M Chromoly spline plugs
High-speed precision ground CV joint with chromoly internals. Has twice the range of the previous design
Spicer 1350 series solid U-Joint
Forged aluminum U-Joint flange
1000+ hp Rating

Note: Emergency brake cable bracket clearance or relocation may be necessary. Failure to check this clearance may damage the driveshaft and void the Warranty
Vehicle Application(s)

This product fits the following models and years

SVT Shelby GT5002007 2008 2009 2010 2011 2012

Customer Reviews 2 item(s)

Great product/easy install
This has been a nice mod to the car. I am pushing 640 rwhp and when this was added I could feel the difference. Install took about an hour in my garage on jack stands. A nice savings in rotating mass as well, about 19 lbs. Review by Damian / (Posted on 1/24/2014)
Nice and Light weight
A musta have peice if your planning on running any sticky tires with some extra power. The original weighs at least 2x what this does and can oinly handle base stock power. This peice is light and capable of handleing just about whatever power you can throw at it.
Installation is simple takes about 20 min on jack stands. Review by Brandon / (Posted on 5/10/2012)

Write Your Own Review