The Brushless DW440 delivers a lot of flow in a small package. With standard 13.8v current, the pump flows 440 LPH at 40 psi to support 1000hp on gas and 750hp on e85.  If even more flow is needed, the 40amp controller and brushless design make this pump an ideal candidate for use at voltages behond typical 13.8v.  The pump and controller have been endurance tested at voltages up to 24v.  At a recommended max intermittent voltage of 20w, the DW440 flows 620LPH at 40psi.

C102 Single/Dual Speed Controller

Single Speed is the simple 100% duty cycle "constant on."  Dual Speed allows you to operate the DW440 at low duty cycle during normal driving conditions and full duty cycle during high load conditions.

C103 PWM Modulated Controller

Allows your DW440 to be fully controlled by your existing OE or aftermarket fuel pump control module's PWM signal.

Quality and Innovation

• 440lph at 40psi - 13.8v
• 620lph at 40psi - 20.0v
• Compatible with all fuels including methanol and e100
• Single-Speed/Dual-Speed, or PWM Controller Options
• No brushes + No commutator = Ultimate Durability

Compact Size - the DW440 measures 4" from inlet to outlet, opening up lots of fitment options that did not previously exist for customers wanting to integrate brushless pumps into ther fuel system.

Bulkhead Wiring - Brushless pumps require a 4-wire connector for digital control.  The DW440 pump kits include a bulkhead harness that allows pass-thru of the 4 wire system via a small 10mm hole which is easily added to an OW module top hat.

Ventury Outlet - Most modern pump modules utilize a venturi jet system to prevent fuel starvation at low tank levels and high G cornering/acceleration.  The DW440 has an integrated 6mm outlet to drive these systems.