Details
Vortech 1999 GT 4.6L V-3 Si-Trim Complete System (Satin)
The 1999 Mustang GT comes from the factory with an impressive 260 horsepower and 302 ft/lbs of torque. A Vortech supercharging system can safely increase this to 364 horsepower and 371 ft/lbs of torque. You will be impressed by the seamless integration of the supercharger system and the true supercar performance it delivers.
This system features the all-new V-3 Si-Trim supercharger. The V-3 supercharger features an internally lubricated transmission, allowing for supercharger installation and operation without oil lines.
- Helical gear design with 3.6:1 step-up
- Includes remote fluid drain hose (attached to supercharger) that allows for simple fluid changes without removing the supercharger from the vehicle
- A ventilated gear case assembly eliminates any potential internal pressure issues that are currently associated with non-vented competitive designs
- Integrated gear case baffling for proper oil control
- Simple oil slinger design does not require separate shaft or bearing set. This provides proper fluid delivery to gears and bearings
- Superchargers are factory pre-filled with our special synthetic fluid.
- Integrated dipstick for simple fluid checks
NOTE: Battery MUST be relocated to the trunk to run the V-3 Si-Trim Blower
Complete and Ready To Run
Vortech supercharging systems deliver maximum value for your performance dollar. Each system is 100% complete, right down to the wire ties. The following items are included with every Vortech supercharging system at the time of purchase (unless otherwise noted):
- All-new Vortech V-3 Series internally lubricated supercharger
- Calibrated fuel system for proper fuel management*
- High performance ignition system with boost timing retard for proper timing curve*
- Custom computer tuning*
- High flow air intake system with a reusable air filter and specially formed polypropylene plastic inlet ducts for minimum restriction and superior fit
- Heat resistant silicone hose coupling
- Premium grade flex hose
- Stainless steel clamps
- Carefully designed and flow tested cast aluminum and/or roto molded urethane air discharge tubing
- Compressor bypass valve
- OEM style single cast 356 aluminum mounting brackets heat treated to T-6 specifications for strength
- Supercharger drive pulley
- Integrated belt tensioner
- Premium drive belt
- Heavy duty mounting hardware
- Tie wraps
- Polished finish
- Heavy duty engine oil lubrication system
- Step-by-step, fully illustrated installation manual
- 3-year limited warranty on most systems
- Mandrel bent, TIG welded and powder coated cooling water re-route kit*
* some applications