Vortech 00-04 GT 4.6L V-3 Si-Trim Complete System (Polished)

Vortech 00-04 GT 4.6L V-3 Si-Trim Complete System (Polished)

The 2000-2004 Mustang GT comes from the factory with an impressive 260 horsepower and 302 ft/lbs of torque. A Vortech supercharging system can safely increase this to 364 horsepower and 371 ft/lbs of torque. You will be impressed by the seamless integration of the supercharger system and the true supercar performance it delivers.

This system features the all-new V-3 Si-Trim supercharger. The V-3 supercharger features an internally lubricated transmission, allowing for supercharger installation and operation without oil lines.

Helical gear design with 3.6:1 step-up

Includes remote fluid drain hose (attached to supercharger) that allows for simple fluid changes without removing the supercharger from the vehicle

A ventilated gear case assembly eliminates any potential internal pressure issues that are currently associated with non-vented competitive designs

Integrated gear case baffling for proper oil control

Simple oil slinger design does not require separate shaft or bearing set. This provides proper fluid delivery to gears and bearings

Superchargers are factory pre-filled with our special synthetic fluid.

Integrated dipstick for simple fluid checks

NOTE: Battery MUST be relocated to the trunk to run the V-3 Si-Trim Blower

Complete and Ready To Run

Vortech supercharging systems deliver maximum value for your performance dollar. Each system is 100% complete, right down to the wire ties. The following items are included with every Vortech supercharging system at the time of purchase (unless otherwise noted):

All-new Vortech V-3 Series internally lubricated supercharger

Calibrated fuel system for proper fuel management*

High performance ignition system with boost timing retard for proper timing curve*

Custom computer tuning*

High flow air intake system with a reusable air filter and specially formed polypropylene plastic inlet ducts for minimum restriction and superior fit

Heat resistant silicone hose coupling

Premium grade flex hose

Stainless steel clamps

Carefully designed and flow tested cast aluminum and/or roto molded urethane air discharge tubing

Compressor bypass valve

OEM style single cast 356 aluminum mounting brackets heat treated to T-6 specifications for strength

Supercharger drive pulley

Integrated belt tensioner

Premium drive belt

Heavy duty mounting hardware

Tie wraps

Polished finish

Heavy duty engine oil lubrication system

Step-by-step, fully illustrated installation manual

3-year limited warranty on most systems

Mandrel bent, TIG welded and powder coated cooling water re-route kit*

*some applications