UPR Mustang Jacking Rails (2pcs.)

UPR Mustang Jacking Rails (2pcs.)



These Jacking Plates are just another great
Innovation that Prevents Major Damage to your outer Rocker Panel.



You can simply slide this up over the pinch welds that connect the
Rocker Panel to the floor pan next to the uni body with these trick
jacking plates.



These can also be welded in place permanently in the location you
like the best for jacking up your car and working on it.



We have seen the following installs from many customers and racers
who love how clean and easy the install and give the unlimited options.



Listed below are the various reasons for each type of installation.



Front Mounted: lifts the Front end one side at a time or the whole Front end
end with 2 jacks to drop oil pan or install K-member or remove and
replace the A-arms or install spring etc.



Middle Mounted: lifts the entire vehicle up on either side with one jack.



Rear Mounted: lifts the Rear end one side at a time or the whole rear end
end with 2 jacks to set pinion angle or change anything or remove and
replace the rear or intsall spring and or control arms etc.



Front and Rear Mounted: Are the most commonly selected install because it
allows for any type of work at the track or at home with the safest possible
setup as these plates will not let the jack slip of fall off because they
seat at the bottom jacking cup.



These were designed to fit 99% of the jacks in the world today and ensure
the safest fastest way to slide the jack under and go.



Sold in pairs. They are ready for you to paint them whatever color your vehicle
is.