Mcleod Shelby GT500 RXT Street...
Mcleod 2010 GT500 RXT Street Twin Disc Clutch Kit (Street) Includes: Mcleod RXT Clutch Mcleod Lightened Steel Flywheel NOTE: The 2010 GT50...//Shop Now
Almost 3 years ago now one of our dealers Thomas Hendrix from Hendrix Engineering had asked us to make a set of axle with different diameters. the reason for his was to help with Wheel hop on certain cars. now this technology is not something new and it was actually created by both GM and Chrysler on SRT8's and Corvettes. Like those cars it works quite well. The way the system works is this, when the torque is applied to the rear wheels thru the drive train. the axles torsionally twist at a certain rate, what happens on cars with certain types of suspension is as they both wrap up at the same time they also release at the same time and cause the wheels to "HOP" with different diameter bars this "wrap up and release" happens at different times helping the wheels to spin. now on a street/strip cars this is a great thing but keep in mind like the factory ones it will have it limitations. What were actually doing here is making one axle stronger and one weaker (one big and one little says it all) so if your building a car that has up to 900Hp and want to eliminated the dreaded "HOP" we have designed this set of axles for you.
What we have done different is this, our skinny bar is smaller in diameter than a standard 28 spline a stock 108mm CV would use and its made from 300m, We have rolled the spline onto a ground piece of the material that during the rolling process raises the spline above the center diameter of the bar (this is done with all rolled splines DSS uses), what this also does is allow us to make the axle with out any internal snap ring (no internal groove for a square edged stress riser during torsional shock loading) We then make the Big bar using our 300 material out of Sweden but its made with a 1-1/2 diameter to balance out the strength. this like the other bar has the rolled splines so at the edge where the race will meet the spline (area of most failures) its much stronger due to the re-forming of the same material instead of taking away grain structure/material like a cut spine. so if your running a car up to or around the 1000hp range (keep in mind auto and 6 speed cars will have different effects on Hp ratings) and want to reduce some of the wheel hop this just might be the axle set for you. please keep in mind a high performance race car will need the axles to be the same diameter for obvious reasons stated above. choose your parts wisely.....
NOTE: This item is special order and may take up to 2-3 weeks to ship.