Ford Racing 96-98 Mustang High Flow Intake Manifold Base Kit

All new 3-piece aluminum casting with tuned runner, rear entry plenum design. Basic runner and plenum geometry was based on extensive dynamometer testing, described high performance cylinder heads, creates an optimized induction system.

The manifold primary runners were designed for maximum airflow using state-of-the-art fluid flow modeling software. Airflow testing has demonstrated a manifold flow loss of less than 10% when compared to bare inlet port with ideal entry conditions. This amount of flow loss is considered to be very low and is less than held the restriction of a typical production manifold Large diameter primary runners produce a significant horsepower increase in the 4000 to 6000 RPM range without loss of mid-range torque.

The intake manifold and installation hardware kits include: inlet duct, dual bore throttle body, shock tower brace (except 1998), and all necessary lines, hoses, and attaching hardware. No hood or hood blanket modifications are required.

Service gasket M-9439-D461 manifold intermediate joint gasket.

NOTE-Hardware Kit Required. High performance computer or tune recommended.